Polymer Sculpture: Bus Stop, Bukowski, Dylan

















































































































Comments

Post a Comment

Popular posts from this blog

Papercrete Recipes updated September 16, 2014

Image
This update is overdue. My recommendation for papercrete at this point, after a few years of experimentation, would be to start with that good ol' three parts substrate to one part Portland cement mix. Since the days of my mower-towed "mini-mixer" I have dabbled with using cellulose insulation, peat moss, vermiculite, and sand as substrate and have come to rely on the three to one mix, substituting one substrate for another depending on it's use.The recipes I posted years ago made for a weak mix. Two parts paper to one part sand to one part Portland cement would be a better starting place. I mix smaller batches by hand these days. The papercrete wall in the picture is covered with a heavy layer mortar made of sand and Portland cement and laced with either joint compound or builder's lime added for plasticity. Both the wall and the sculpture still stand. Just remember that everything posted here is in the spirit of experimentation. Thanks for reading. Mike ...
Read more

Hypertufa/Papercrete Planter

Image
 The base coat on this planter is plain old hypertufa consisting of (using 2-pound coffee cans for measurement) one can of peat moss, one of Pearlite, ½ of Portland Cement, one of water (there about), and a little lime putty. I’d made the armature using two old, sun-beaten, brittle planters that were ready for the landfill fastened together with sheet metal screws and covered with two layers of poultry wire (see photos below). So far I’ve found that this type of Hypertufa mix is good for casting but is honestly difficult to daub onto wire without either ready mix joint compound or lime putty to make it stickier. Even then it doesn’t seem very workable. Perhaps more cement to the mix would make it stick to the armature better. I'll continue to research and experiment. As it was, I applied the hypertufa with some force to push it deep into the wire and keep it from falling off. For the design on front I used the same mixture as above, but substituted cellulose insulation for...
Read more